Supply belt brush, rubber belt brush, nylon belt brush1

The belt brush can be regarded as a kind of pure hand-made brush variety, and it is not an exaggeration to say that it is a special-shaped brush. The belt brush is made by first punching holes on the belt, then fold the brush filaments in half and thread them on the belt with nylon thread, and then trim the bristles. Because of the softness of the belt, its manufacturing process seems simple, but it is really troublesome to make, especially the planting stage, which is done by experienced employees alone. At present, there is no high-quality equipment for mass production in China. General machinery cannot be operated at all. First, after punching holes on the belt, fold the bristles in half and thread them on the belt with nylon thread, and then trim the bristles. The application of belt brushes should be used in special production lines to transport products through belt brushes or to remove dust from products; wood industry, machinery manufacturing, food industry, sanitation industry, hardware industry, electronics industry, etc. Some belt brushes are not only used in industrial production, but a small amount of them are turned into handicrafts and enter the field of collection. The characteristics of belt brushes At present, because the domestic belt brushes are made by hand, the nylon thread for stringing will inevitably be exposed on the back, but there is no need to worry about the nylon thread for stringing being broken. Usually the quality of the nylon thread for stringing is similar. For fishing line, it is very tough and abrasion resistant. There are two types of belts: long strip and ring. The color is gray, red, green, etc., and the width depends on different equipment. The hair length on the belt brush is also controllable, and its length can be set when used in different equipment production. For details of the belt brush, please visit www.mxbrushmachinery.com Contact number Contact person Mr. Xu QQ1224158858